What is a patch fitting and what is it used for?

Patch fitting is fixed on the edge of the door, to install other parts of the clip. Patch fittings are mostly made of metal, divided into two halves, the installation of the door plate in which the screws will tighten the door clamps, so that it clamps the door plate, fixed in the door, to facilitate the installation of other components.

How to adjust the bathroom patch fitting off?

First of all, note that a person should not adjust the whole glass door, because the glass door is very heavy, it is not good to hurt. (If the bathroom door is another material, only from the bathroom door patch fitting to determine this glass door + bathroom patch fitting)

1. bathroom glass door bias, not perpendicular to the ground

A. this situation is mostly caused by damage to the internal structure of the bathroom door patch fitting or bathroom door patch fitting attached to the wall, the location of the glass offset. can first screw all the screws of the bathroom door clip, such as those found loose, then correct the position of the bathroom door patch fitting, and then tighten the screws can be.

C.such as all the screws are no signs of loosening, the bathroom door patch fitting internal spring structure damage, the need to replace the bathroom door patch fitting. (Less likely, but if the interior of the bathroom door patch fitting is welded is possible)

2. The bathroom glass door off, and the ground vertical

A. this situation is mostly caused by the bathroom door patch fitting and glass between the gasket aging or bathroom door patch fitting attached to the wall, the location of the glass offset.

B. Judgment is the gasket aging to replace the gasket.

How to install the glass door clamps?

1、Positioning, line

By the fixed glass and movable glass door combination glass door, unified alignment positioning, according to the design and construction drawings requirements, put out the positioning line of the glass door, while determining the position of the door frame.

2, the top of the frame limit slot installation

Limit slot width should be greater than the glass thickness of two to four millimeters, and slot depth of ten to twenty millimeters. Installation, the beginning of the two metal decorative plate edge line led by the bulletin where the line, followed by the edge line for the top of the door frame limit slot installation, through the glued mat board to adjust the slot depth in the slot.

3, metal finish wood bottom bracket installation

Fix the square wood on the ground, and use universal adhesive to glue the metal trim panel on the wood. If you use an aluminum alloy square tube, you can use an aluminum angle fixed on the frame column, or use wood screws to fix the wood tiles buried in the ground.

4, vertical door frame installation

The centerline of the bullet-nailed door frame is square wood, followed by plywood to determine the shape and location of the door frame column, and finally wrapped metal decorative surface. When wrapping the trim put the trim face joint position on both sides of the installation of glass in the door position.

5、Fit the glass

Use the glass suction cup machine to suck the thick glass tightly and lift the thick glass panel to move to the installation position. First, insert the upper part of the glass into the limit slot at the top of the door frame, and then put the lower part of the glass on the bottom bracket.

6、Fix the glass

In the bottom bracket on the square wood inside and outside nail two small square wood strips to thick glass in the door, the square wood strip painted with universal adhesive, and the finished metal glued in the square wood strip.

7、Glass glue seal

In the top limit groove and the bottom of the groove on both sides of the mouth, as well as the thick glass and frame pillars of the seam, such as the injection of glass glue seal, with tools to scrape off the excess glass glue.

8、Glass docking

Glassdoor fixed part due to the size of too large and need to splice, its butt seam to have two to three millimeters of width, the glass plate edge to be chamfered processing.